Smittybilt C9989QC Nerf-Step Instrukcja Użytkownika Pobierz pdf

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd. Compton, CA 90220

Installation Instructions

Nerf-Step (Part # C9989QC)

99-06 Chevy/GMC Silverado/Sierra

Extended Cab, Short Bed

NOTE: Carefully read entire instructions thoroughly before attempting to install this part.

Drilling is required for installing of these bars. It is recommended to have some additional

help with the installation process.

Parts Included Qty Tools Needed

5/16” x 1” carriage Bolt 12 Drill and 3/8” drill bit

5/16” Nut 12 ½” wrench or ratchet with socket

3/8” Washer 12

Picture is for sample use, may not be actual bars

Step 1:

Open and identify the bars. The short end of the bar goes towards the front of the vehicle.

Position the bar up to the truck approximately ¾” to 1” from the front wheel well opening.

(If you have over-sized tires you can mount the bar further back to insure you have tire-turning

clearance). Make sure not to hit the cab brace: this will cause the step plate not to be parallel

with the ground.

Step 2:

Hold the bar on the underside of the truck with the angled flange on the bracket below the pinch

weld. (Fig A) Use the slotted holes in the angled flange as a guide to mark the holes to be

drilled into the pinch weld. (6 per side, the angle of the flange will appear to be at a different

angle than the pinch weld this is normal and the bar will “set” properly when installed. ) Once

holes are marked carefully set the bar to the side.

1 2 3

WWW.SMITTYBILT.COM For

WWW.SMITTYBILT.COM For

WWW.SMITTYBILT.COM For

Brak uwag

Smittybilt C9989QC Nerf-Step Instrukcja Użytkownika